38
A100K10652
IP DECT 6000 System Installation & Configuration Guide
7.2 Installing the Battery
,
Take the following precautions before you handle the batteries:
●
Do not replace the batteries in potentially explosive environments
such as rooms where flammable liquids or gases are present.
● Do not dispose of the battery in a fire as it will explode.
●
Only use the proper batteries and the approved charger to charge
the batteries.
●
Only use battery with part no. 84743411 in the EX Handset. Do
not use these batteries with other products. These batteries were
designed specifically for use with the EX Handset and the charger
ONLY. Improper use of the batteries may cause them to become a
fire hazard.
●
Only use battery with part no. 84743418 (ICP73048) in the Rough/
Office Handset. Do not use this battery with other products. This
battery was designed specifically for use with the Rough/Office
Handset and the charger ONLY. Improper use of the battery may
cause them to become a fire hazard.
●
Do not do anything that would cause the battery to short circuit.
●
Do not let the battery or the charger come into contact with
conductive metal objects.
7.2.1 Installing the Battery on EX Handset
To change the battery:
5. Unscrew the plate on the rear of the handset to access the battery
compartment. Use a normal screw driver.
6. Insert the screwdriver into the small crack behind the back cover and
lift to remove it.
7. Place the battery plug in the slot in the battery box.
8. Insert battery with its label showing.
9. Replace the back cover.
Figure 18
Removing Back Cover from EX Handset
7.2.2
Installing Battery on Office Handset
To install the battery:
