47
IP DECT 6000 System Installation & Configuration Guide
A100K10652
8.4
Configuring the Server 6000 Using a Static IP
Address
This section describes how to configure an Server 6000 using a static IP
address.
)
The Server 6000 is predefined to use a static IP address. It is highly recommended
to configure the Server 6000 using a static IP address.
This section contains information about:
● “General Configuration”
● “Wireless Server Configuration”
● “SIP Configuration”
● “Security Configuration”
8.4.1
General Configuration
You can define IP, DNS and NTP settings for the Server 6000 on the
Configuration > General
page.
To configure the Server 6000:
1. Click
Configuration
, and then click
General
.
2. Click
Use Static IP Address
.
3. In the
IP addr
field, enter the IP address of the IP DECT Server
6000.
-the IP address should be in the same network range as that of the
AlphaCom/ACM exchange
-Contact your system administrator for more information.
4. In the
Netmask
field, enter a new network mask.
-Contact your system administrator for more information.
5. In the
Gateway
field, enter the IP address of the default gateway.
-The default gateway serves as an access point to another network.
Contact your system administrator for more information.
6. In the
MTU
(Maximum Translation Unit) field, enter the size of the
largest packet that your network protocol can transmit (optional).
7. In the
Domain
field, enter the domain name of the system (optional).
8. In the
Primary Server
and
Secondary
Server
fields (under
DNS
