61
4.
Route condensate drain
D
out of the
heat pump in such a manner that it
does not contact hot, vibrating or
sharp-edged components.
Connect the condensate hose to the
on-site sewer via a siphon (min.
backup level 60 mm).
Technical guide
!
Please note
The condensate hose can
freeze up.
Thermally insulate the con-
densate hose against frost; if
required, install auxiliary heat-
ing.
5.
Route hydraulic lines
A
and
C
out
of the heat pump and connect with
the lines in the foundations duct.
!
Please note
Water-carrying pipes can
freeze up.
Thermally insulate pipes
inside and outside the heat
pump against frost.
Fitting the flow temperature sensor, secondary circuit
The flow temperature sensor for the sec-
ondary circuit is installed in the heating
water flow
inside the building
.
Note
If an instantaneous heating water heater
is installed, fit the flow temperature sen-
sor for the secondary circuit in the heat-
ing water flow downstream of the
instantaneous heating water heater.
Installation sequence
Connecting the heating circuits and condensate…
(cont.)
5692 875 GB
Installation
Summary of Contents for Vitocal 300 AWO-M-AC 301.A
