Vector VEC-VA Series, Programming Manual

Page: 93 / 649

VA Motion Controller Programming Manual
88

panel function introduction
 
cold start : indicates that the PLC starts executing the program from the initial state,
anDAll variables are defined initial values
​​
at the start time;

Warm start : Indicates that the hold type variable in the program maintains the state at the
last stop, and the other variables are the initial state.

Tip: Click the
“
Stop
”
button in the
“
Run
”
state to pause the operation of the PLC . All
the variables in the program will remain at the moment before the stop. At this time, the
“
warm
start
”
button is available. Click this button to continue the program. run.
 
: It is used to choose whether to save the program downloaded by the user (after
the VA motion controller is powered off). Before the user program is installed, you need to click
the
“
More
”
pop-up window to check the box as
“
Guided Project Permanent Station
”
. Leave"
and then click "Close" as shown in the figure (Note : If unchecked, the PLC will not be able to run
the last downloaded program after power-on, that is, the motion controller does not save the last
downloading program. Need to reinstall the program)

Info:It is used to view the PLC running status, the bytes occupied by the program memory,
the current scanning period setting, etc.; as shown