Toshiba STRATA CIX, Programming Manual

Page: 185 / 248

Advanced Integrations and Applications
AMIS Networking
Strata CIX Voice Mail Programming 01/07
10-9
A
d
va
n
c
e
d
In
te
gr
at
ion
s
a
n
d Ap
pl
ic
ati
o
n
s
Destination System Number
The Destination System Number consists of a country code (the digit “1” in North America), area
code, and seven-digit phone number. This number not only identifies the calling system, but can
also be used by the administrator to configure the local system to enable message replies.
Configuring Voice Mail for AMIS
There are two steps to configuring voice mail to act as an AMIS node:
1. Set the voice mail AMIS system parameters.
2. Create Gateway User Agents for each remote system with which voice mail communicates and
Proxy User Agents for each remote user that wishes to have a local address.
Step 1: Set AMIS Parameters
For AMIS to operate correctly, you must check the AMIS configuration parameter settings in the
voice mail system and modify their settings appropriately. See
“Modify Parameters” on page 3-30
for instructions on modifying the settings for the AMIS parameters shown in Table .
Table 10-2 AMIS Parameters
Parameter Description
sys_amis_area_code
Area code of the resident voice mail system. Single quotes are required.
Default: blank comment line
sys_amis_country_code
Country code of the resident voice mail system. Single quotes are required.
Default: comment line starting with 1 for North America.
sys_amis_disk_full
Percentage of the hard drive that must be free in order for voice mail to
accept new AMIS messages. If free space is less than this figure, voice mail
tells the calling AMIS system that the hard drive is full.
Default: 5 (percent)
sys_amis_enabled
Whether voice mail processes incoming AMIS calls.
Possible values:
True: Voice mail processes incoming AMIS calls.
False: (default) AMIS calls told that this node is not accepting network
calls.
sys_amis_failure_retry
Number of retries after failure.
Possible values: 0~9 (default = 3)
sys_amis_loopback_enable
Enables the AMIS loopback test feature.
Possible values:
True:
(default) enables feature
False: disables feature
sys_amis_ltm
User Agent number to use for the AMIS Loopback mailbox. User Agent other
AMIS nodes can use for testing the network. Any AMIS message to this User
Agent is sent back to the sender, if accessible from this voice mail system.
Possible values: valid User Agent number.
Default: 989
sys_amis_max_msg Maximum number of messages the AMIS system can receive.
Default: 1000