G7 ASD Operation Manual
61
The magnitude of the AM/FM output signal at full-scale is selection-specific and may be
adjusted (see
F671
and
F006
) to fit application-specific requirements.
Table 7
shows the default
full-scale output setting of the AM/FM terminal for each selection. The column on the right side
of
Table 7
shows the actual AM/FM output for an EOI display of 100% (default setting).
Table 7. Output terminal selections for the AM, FM, FP, and Analog 1&2 terminals.
Function
AM/FM Output Value at
100% EOI-Displayed Output
Output Frequency (FM and FP default setting)
Maximum Frequency
Frequency Reference
Output Current (AM default setting)
150%
DC Bus Voltage
Output Voltage (
Analog 1 default setting)
Post-compensation Frequency (
Analog 2 default setting)
Maximum Frequency
Speed Feedback (realtime)
Speed Feedback (1 sec filter)
Torque
150%
Torque Command
Internal Torque Base
Torque Current
Excitation Current
PID Feedback Value
Maximum Frequency
Motor Overload Ratio
Motor Overload Trip Point Setting
ASD Overload Ratio
ASD Overload Trip Point Setting
PBR (DBR) Overload Ratio
DBR Overload Trip Point Setting
PBR (DBR) Load Ratio
Maximum DBR Duty Cycle
Input Power
1.73 * input voltage * ASD rated current
Output Power
Peak Output Current
150%
Peak DC Bus Voltage
PG Counter
32767 Encoder Pulses
Position Pulse
RR Input
100%
VI/II Input
RX Input
RX2 Input
FM Output (used for factory testing only)
AM Output (used for factory testing only)
Meter Adjust Value
Analog Output
Load Torque
150%
