Toshiba ESTUDIO170F, Service Manual

Page: 417 / 492

11
January 2005 © TOSHIBA TEC e-STUDIO170F Troubleshooting
11 - 5
[ 2 ] KEY TEST [MENU], [9], [2], [02]
This test checks the key switch operation on the Operation panel.
1) Use the [ Ç ] or [ È ] key to select “02. KEY TEST”, and then press the [ENTER] key.
2) Press all the keys except the [STOP] key. At this time, the status of each key pressed is shown at
the lower right on the screen.
Remark:
The statuses of the keys shown when pressed are listed in the table below.
When all the keys except the [STOP] key are pressed, the display will show the following screen.
Remark:
If no key has been pressed and a period of 10 seconds has elapsed, the test result will be “NG”.
Key Status Table
Key name Display Key name Display
[0] to [9], [#], [*] TK0 to TK9, #, * [ Ç /MENU] UP/MENU
[MULTI/CHANGE CODE] MULTI [ Å ] LEFT/BACK
[SPEED DIAL/ALPHA] ABB [ Æ ] RIGHT
[REDIAL/PAUSE] PAUSE [ È ] DOWN
[MONITOR] MONITOR [JOB CANCEL] CANCEL
[START] START [ENTER] ENTER
[STOP] STOP [DIRECT SEND] A
[COPY] COPY [TX REPORT] P
[MODE] MODE [CHAIN DIAL] C
[CONTRAST] CONTRAST [JOURNAL] M
[INSERT] INSERT [AUTO] R
[DELETE] DELETE One touch keys OT01 to OT19
[JOB STATUS] JOB STATUS [SHIFT] SHIFT
[SUPER ENERGY SAVER] POWER SAVE
KEY TEST
PRESS [STOP] LAST
Pressing key status (When [SHIFT] key pressed)
KEY TEST
SHIFT
KEY TEST
PRESS [STOP]