Toshiba ESTUDIO170F, Service Manual

Page: 103 / 492

4
January 2005 © TOSHIBA TEC e-STUDIO170F Function Settings
4 - 43
4) Use the [ Ç ] or [ È ] keys select “02.SET FUNCTION” item, then press the [ENTER] key, or press
[02], then press the [ENTER] key.
Bit 7 is shown on the LCD display as the left most digit. By entering 1 or 0 in the bit with the desired
function, the function is to be set. Press the [ENTER] key to store the new setting and advance to
the next function.
Note:
Use the [ENTER] key to advance to the next function. Use the [>] key to move to the next bit.
Use the [<] key to move to the previous bit, if already at bit 7 (the left digit), the [<] key will move
to the previous function.
Remark:
To end the service mode, press the [STOP] key to return to the standby mode.
• When the facsimile is turned OFF:
1) Turn the power switch ON while holding the dial keys [1] and [3] down.
Note:
The service mode continues until the service mode end operation is performed or the power is
turned off. Therefore, be sure to end the mode when the tests are finished in a general way.
Bit 7 Bit 0
FUNC0 =XXXXXXXX
Displays the numeric value to be entered now
(can only be altered at the point of the blinking cursor).
XXXXXXXX
Displays the numeric value currently set (cannot be
changed).