Toshiba ESTUDIO170F, Service Manual

Page: 310 / 492

e-STUDIO170F Removal/Replacement/Adjustment January 2005 © TOSHIBA TEC
8 - 2
Warning
• Following are NON-REPAIRABLE parts. Never try to disassemble these parts.
- Drum unit
- Toner cartridge
- CIS
- LSU
- Fuser
• Be sure to use screwdrivers suitable for the respective screws.
• Do not use damaged parts or screws. The use of damaged parts or screws may result in mal-
function or failure of the machine.
• When disassembling or reassembling, do not touch the PC boards. Static electricity on you
can damage parts. Before touching any PC board, be sure to ground yourself.
• When the drum unit is removed from the machine, do not touch the drum surface. Also place
the toner cartridge and drum unit on a level surface.
• Do not leave the drum unit exposed to room light for more than a few minutes, or the drum
unit may become damaged and unusable.
Notes:
• Before disassembling, be sure to print out the following programming lists: Abbreviated dial
list, alphabet dial list, group list, service parameter list. When the power is shut off, this data
may be lost or return to their initial values.
• Before disassembling, remove the phone line cord, handset, process unit (toner cartridge,
drum unit), interface cable, and paper tray.
• All screws are standard ISO. And all dimensions are given in mm.
• Be sure to fix and plug in the power cable securely after the installation so that no one trips
over it.
• Be careful not to touch the sharp edge on the left side frame indicated in the figure.
Fig.8-2
Sharp edge
Sharp edge
Sharp edge
Left side frame