Toro Groundsmaster 328-D, Service Manual

Page: 153 / 402

________________________________________________________________________________________________________________________________________________________
Starting Problems (continued)
Condition Possible Cause Correction
Nothing happens when start
attempt is made. Battery is dead. Charge battery. Replace battery if
it will not hold a charge.
Loose or corroded battery cables.
Loose or corroded ground. Clean and tighten or repair as
necessary.
Fuse open. Check fuse and replace if fuse is
open. If fuse burns out often, find
and correct cause.
Ammeter faulty. Test ammeter and replace if faulty.
Ammeter wiring loose, corroded or
damaged. Repair wiring.
Ignition switch faulty. Test ignition switch. Replace if
faulty.
Ignition switch wiring loose,
corroded or damaged. Repair wiring.
Traction neutral switch out of
adjustment or faulty. Test switch and replace if faulty.
Make sure wires are connected
to “COMMON” and “NORMALLY
OPEN” (N.O.) terminals.
Traction neutral switch wiring
loose, corroded or damaged. Repair wiring.
PTO switch out of adjustment or
faulty. Test switch and adjust or replace
if faulty.
PTO switch wiring loose, corroded
or damaged. Repair wiring.
Starter interlock relay wiring loose
corroded or damaged. Repair wiring.
Starter interlock relay faulty. Test relay and replaced if faulty.
Starter solenoid wires loose,
corroded or damaged. Clean and tighten or repair as
necessary.
Starter solenoid faulty. Test starter solenoid. Replace if
faulty.
Groundsmaster
®
300 Series Page 6 - 7 Troubleshooting
(Groundsmaster 345)