Toro Groundsmaster 328-D, Service Manual

Page: 202 / 402

l
7. After drilling, put a chisel in position across the hole
and strike sharp y to break the ring. Replace with a new
ring at time of reassembly (Fig. 11).
Wear protective safety goggles when break­
ing the retaining ring. Personal injury could
result from flying metal particles. Keep all
personnel away during this procedure.
WARNING
Figure 11
8. Inspect the shaft for possible damage (Fig. 12).
Inspect the sealing surface of the hub and shaft. Re-
place it if the seal has grooved the surface more that
1/64 inch (0.4 mm).
9. Put a new grease seal, brake assembly, and a new
grease packed bearing (in that order) onto the axle
shaft.
Figure 12
10. Press the assembly until the bearing is firmly seated
against the axle shaft shoulder (Fig. 13).
Figure 13
Repairs Page 7 - 6 Groundsmaster
®
300 Series