Toro Groundsmaster 328-D, Service Manual

Page: 292 / 402

B
B
A
29 37 36
35
39 32
31
33
30
Apply
30
34
0.34
±
0.03
″
″
31
clutches must face
cl
l
Never-seeze
Detail A Detail B
0.040 MAX
Arrow end of roller
6-bolt flange end of
utch housing
toward rear ax e)
Figure 9
5. Put thrust washer (Item 14) in housing adjacent to
roller clutch as shown. Press both seals (Item 13) into
end of housing to dimensions shown. Seals must be
installed with lip facing out.
6. Install clutch assembly onto yoke shaft, then install
other thrust washer. Install retaining ring (Item 29) to
secure clutch assembly to shaft. Install axle coupling
(Item 37) to clutch housing with six (6) capscrews and
lockwashers, then tighten capscrews evenly.
7. Lubricate clutch through grease fitting (Item 32) with
No. 2 General Purpose Lithium Grease.
Installing Drive Shaft.
1. Apply never-seize to splines of traction shaft and axle
input shaft.
2. Slide clutch end of drive shaft onto rear axle shaft
spline, aligning roll pin hole in shaft with hole in axle
coupling (Item 37). Install roll pin (Item 35) through
coupling and shaft.
3. Tighten two (2) capscrews (Item 44) and locknuts
(Item 43) to secure coupling to shaft.
4. Secure drive shaft yoke flange to flange on front axle
differential with six (6) socket head capscrews and
lockwashers (not shown).
Repairs Page 10 - 6 Groundsmaster
®
300 Series