Toro Groundsmaster 328-D, Service Manual

Page: 214 / 402

10. Install the shim and snap ring onto the end of the
pinion shaft. Use the thickest shim possible which will
permit installation of the snap ring (Fig. 44). Limit the
end play to 0.000 - 0.005 inch (0.000 - 0.127 mm).
Figure 44
11. Apply a small bead of Permatex No. 2 or silicone
sealant to the outer edge of the carrier bore. Install the
expansion plug (or seal if equipped with flange for 4WD)
into carrier until plug or seal seats firmly in carrier bore
(Fig. 45).
Figure 45
12. Install the spur gear cover. Use Permatex No. 2 or
silicone sealant when installing the cover. Tighten the
capscrews to a torque of 25 - 40 in.-lb. (Fig. 46).
Figure 46
Repairs Page 7 - 18 Groundsmaster
®
300 Series