29. Install the front gear case and gasket, using PER-
MATEX No. 2 on gasket surfaces. When installing the
gear case insert the tie rod and tie rod stopper spring
into the hole in the cylinder block under injection pump.
Install the crankshaft pulley and key. Torque the retain-
ing nut to 144 - 180 ft-lbs. (20 - 25 KgM).
30. Install the oil screen and the oil pan using a new
gasket.
Figure 87
Installing gear case
31. Reinstall the speedometer unit while rotating the
speedometer shaft. Make sure that the O-ring is prop-
erly installed. Apply oil to the outside surface of valve
lifters and insert the lifters into the cylinder block in the
order of which they were removed. Install the push rods
into the lifters in the order in which they were removed.
32. Install the cylinder head assembly.
Figure 88
Inserting tappet
33. Install the fuel injection pump.
34. Install the oil pump and oil filter if they have been
removed.
35. Install the water pump.
36. Install the starter if it has been removed.
37. Install the overhauled engine onto the machine
following the reverse procedure for removing the engine
from the machine.
Figure 89
Installing injection pump
Cylinder Block Overhaul
Page 4 - 64
Groundsmaster
®
300 Series
Summary of Contents for Groundsmaster 328-D
