Thermo Scientific 5028i, Instruction Manual

Page: 274 / 330

C-Link Protocol Commands
Calibration
B-34 Model 5028
i
Instruction Manual Thermo Fisher Scientific
set cal vac flow offset a/b
This command automatically sets the flow offset based on the vacuum
pressure entered at the time of calibration. The following example
successfully sets the flow offset value.
Send: set cal vac flow offset a
Receive: set cal vac flow offset a ok
Send: set cal vac flow offset b
Receive: set cal vac flow offset b ok
coef pm a/b
This command reports PM coefficient. The following example reports
that the PM coefficient is 1.200.
Send: coef pm a
Receive: coef pm a 1.200
Send: coef pm b
Receive: coef pm b 1.200
set coef pm a/b
value
This command sets the PM coefficient to user-defined values to value ,
where value is a floating-point representation of the coefficient. The
following example sets the PM coefficient to 1.200.
Send: set coef pm a 1.200
Receive: set coef pm a 1.200 ok
Send: set coef pm b 1.200
Receive: set coef pm b 1.200 ok
flow pres span a/b
This command reports the flow pressure span recorded at the time of
calibration. The following example reports that the flow span is 1.2.
Send: flow pres span a
Receive: flow pres span a 1.200
Send: flow pres span b
Receive: flow pres span b 1.200
set flow pres span a/b
value
This command sets the flow pressure span to value , where value is a
floating-point representation of the pressure span specified at the time
of calibration. The following example successfully sets the new value for
flow pressure to 1.5.
Send: set flow pres span a 1.5
Receive: set flow pres span a 1.5 ok
Send: set flow pres span b 1.5
Receive: set flow pres span b 1.5 ok