Thermo King TriPac Envidia, Installation Manual

Page: 62 / 80

60
Installing Battery Cables (continued)
4. NEGATIVE BATTERY CABLE
NOTE: Do not attach both the positive and the negative cables to a single battery. For best results, attach the
positive cable to the first battery and the negative cable to the last battery as shown.
a. Route the negative cable from the TriPac ENVIDIA battery box to the tractor’s negative battery
terminal, cut to length and strip 1/2 to 3/4 in. (13 to 19 mm) of insulation from cable end.
b. Slide the supplied BLACK heat shrink tubing and terminal ring onto the end of the cable. Attach the
terminal ring firmly to end of cable.
c. Position heat shrink tubing to cover exposed wires on the terminal ring and use a heat gun to shrink
the tubing in place.
d. Install the negative cable terminal lug onto the battery’s NEGATIVE (-) connection and tighten
securely.
e. Apply Superlube (PN 203-524) or equivalent onto the battery’s connection.
5. TriPac Envidia BATTERY BOX
a. Connect positive cable terminals to each of the batteries.
b. Connect negative cable terminals to each of the batteries.
6. INSTALL FUSE (F13)
a. Remove the nuts from the fuse holder, place the 175 amp fuse onto the studs, and on top of the
battery cables lugs and reinstall the nuts. Tighten the nuts to 120 in-lb (13.5 N•m).
b. Close the fuse holder cover securely.
c. The TriPac ENVIDIA system is now powered.
Figure 34: Installing Battery Cables and Fuse