Thermo King TriPac Envidia, Installation Manual

Page: 47 / 80

45
Battery Box Harness Installation (continued)
From Evaporator/Control Box
10. From the Evaporator/Control Box route the RED and BLACK (4 AWG) Compressor Drive Module power
cables through the floor access hole with the refrigerant lines. Route cables to the back of the TriPac Envidia
Battery Box.
NOTE: These cables are pre-connected to the Compressor Drive Module inside the
Evaporator/Control Box.
11. Route the positive cable (RED) through the upper hole in the back of the battery box to the F10 (150 amp) fuse
in the holder.
12. Cut cable to length and install terminal with 1/4” hole.
13. Connect to F10 fuse holder terminal. Torque nut to 120 in-lb (13.5 N•m).
14. Route the negative (BLACK) cable through the lower hole in the back of the battery box to the chassis ground
stud.
15. Cut cable to length and install terminal with 3/8” hole.
16. Secure to existing cables.
17. Connect to chassis ground stud.
Figure 23: Battery Box harness connections