57
Heater Fuel Pump Connections (Heat Option)
CAUTION: To prevent the heater from starting unexpectedly, set all electrical controls to the OFF position
BEFORE connecting wires to battery.
Special Tools Required
Wire Cutters
Terminal Crimping Tool
1.
Route the
heater fuel pump harness
(installed earlier) to the heater fuel pump and cut the wires to the correct
length.
a.
Strip wire ends, slide on rubber sealing boots and attach pin terminals securely with crimping tool.
b.
Insert pin terminals into connector body until they lock in place.
c.
NOTE: The pump is not polarity sensitive. The wires can be installed in either location of the
connector body
d.
Snap locking cover closed on connector body.
e.
DO NOT
connect the fuel pump harness to the fuel pump at this time
.
The fuel pump harness will be
attached later after the fuel pump has been primed
.
Figure 32: Heater Fuel Pump Connections
Summary of Contents for TriPac Envidia
