47
Ignition Switch and Harness Installation
IMPORTANT: The Ignition Sense harness wire must be connected to the ON or RUN position of the tractor’s
ignition system. This will prevent the HVAC system from operating and allow battery charging when the tractor’s
engine is running.
Locate the
Ignition Sense
harness supplied loose in the installation kit.
1.
Connect the 2-pin connector to the Ignition (J10) connector on the Evaporator/Control Box connector panel.
2.
Route the harness towards the tractor’s ignition switch.
3.
Connect the end
with
the diode and fuse to the ON or RUN position of the tractor’s ignition switch.
4.
Secure the harness adequately with band wraps.
NOTE: On some truck models the ignition switch acts only as a selector device connected to an ignition module. There
may not be system power available at the switch. The TriPac Envidia system may not function correctly. In this case
locate the truck ignition module and connect to the ON or RUN outpu
t.
Figure 25: Ignition Switch Harness Connections
Summary of Contents for TriPac Envidia
