Thermo King T-1000R, Maintenance Manual

Page: 28 / 282

Maintenance Inspection Schedule 4-4
UNIT MODELS: T-SERIES SPECTRUM
*Do not mix antifreeze types.
** Wet cell battery may need to be topped up more regularly where unit is operating in high ambients for longer periods. Refer
to service bulletin for Silver Calcium Batteries
*** EON battery is maintenance free and does not require topping up of electrolyte.
**** If no drain plug is available in the fuel tank the tank manufacturer should provide clear instructions for fuel cleaning. For
fuel supplies taken from the truck tank the truck manufacturer's instructions should be adhered to.
5* Test and service the injector nozzles every 8,000hrs. The injector service may be required more frequently depending on the
type and specification of diesel fuel used.
Refer to the latest service bulletins for additional information.
The service technician is responsible for assessing the
condition of all parts & components found during any service
operation to be in a condition suitable for further operation
up to the next scheduled service. If parts not considered in
suitable condition, they should be replaced.
INSPECTION
A SERVICE
Every 1000 hours
Or every 6 Months
(whichever comes
first)
SERVICE
B SERVICE
Every 2000 hours
Or every 12
Months
(whichever comes SERVICE
C SERVICE
Every 4000 hours
Or every 24
Months
(whichever comes Check/Inspect/Adjust/Change/Replace
REMOTE EVAPORATOR (S)
Electrical
  
Inspect wire harness for damaged wires or connections.
  
Check defrost operation, including drain heaters operation &
defrost termination.
  
Check fan motor start speed sequence and operation.
Refrigeration
 
Leak test remote evaporator & refrigerant lines - annually or as
required for F-Gas control regulations
 
Operate the two/three zones in inverted operation to confirm the
unit's ability to operate in reverse cycle for both zones.
Structural
 
Check defrost drains for leaks and water flow
  
Visually inspect unit for fluid leaks.
  
Visually inspect unit for damaged, loose, or broken parts.
 
Clean evaporator coils and defrost drains of loose debris
Operator Weekly / Pre-Trip Checks
Check fuel supply.
Check & adjust engine oil level.
Perform Automatic Pre-Trip
Listen for unusual noises, vibrations, etc.
Visually inspect unit for fluid leaks (coolant, oil, refrigerant)
Visually inspect unit for damaged, loose or broken parts (includes air ducts and bulkheads, if so equipped)