Thermo King T-1000R, Maintenance Manual

Page: 266 / 282

Electric Standby Diagnosis 14-2
Electric Standby (Optional) Diagnosis
Condition Possible Cause Remedy
Unit turned On—Microprocessor
display does not come on Battery discharged Charge or replace battery
Faulty battery cable connections Clean battery cables
Fuse F21 blown Check for short circuits and replace
fuse
Fuse F4blown Check for short circuits and replace
fuse
Fuse F1 blown Check for short circuits and replace
fuse
Fuse F2 blown Check for short circuits and replace
fuse
Open circuit Check HMI Harness
Faulty On/Off relay K4 Check On/Off relay K4
Unit turned On—Microprocessor
display comes on but electric
motor does not run No standby power Provide power to unit; check power
at:
1. Power source
2. Power plug
3. Motor contactor hot side
4. Motor contactor load side
(contactor closed)
5. Overload relay
6. Motor terminals
Diesel operation selected Select ELECTRIC
Unit in NULL Check setpoint and box temperature
Fuse F25 blown (Fuse F5 T-500R/
T-Dairy) Check for short circuit and replace
fuse
Faulty LPCO (T-500R/T-Dairy) Check LPCO
Faulty HPCO Check HPCO
Open or faulty overload relay Determine cause and reset or
replace overload relay
Faulty run relay K1 (K9 T-500R/
T-Dairy) Check run relay K1
Faulty diesel/electric relay K5 Check diesel/electric relay K5
Faulty phase select module Check phase select module
Faulty motor contactor Check motor contactors
Open circuit Check 8, ER, EOL, 7E, 7EA, 7EB,
7EC, CH, L1, L2, and L3 circuits
Faulty drive motor Check drive motor
Batteries discharged Charge or replace batteries
Electric motor hums but does
not run Locked rotor (overload relay will
open after a period of time) Remove interference
Locked compressor Repair compressor
Defective clutch on engine (locked
up) Repair or replace clutch