Refrigeration Maintenance
10-26
Installation
1. Lift the compressor into the unit and install the mounting bolts.
2. Clean tubes for soldering. Solder discharge line to compressor.
3. Install the suction valve using a new gasket soaked in refrigerant oil.
4. Solder the liquid injection tube to injection fitting.
NOTE: Use a heat sink or wrap the injection fitting with wet rags before soldering the connection to prevent damage to the
O-ring in the fitting.
5. Pressurise the system and test for refrigerant leaks.
6. If no leaks are found, evacuate the system. Replace the compressor/electric motor belt and adjust the tension.
7. Charge the unit with refrigerant.
8. Operate the unit at least 30 minutes and then inspect the oil level in the compressor. Add or remove oil if necessary.
9. Check the refrigerant charge and add refrigerant if needed.
Scroll Compressor Shaft Seal Replacement
Parts Required:
• O-ring, P/N 33-2998
• Dust Shield, P/N 22-1037
• Stationary Seal Member, P/N 22-1038
• Rotating Seal Member, P/N 22-1039
• Mounting Screws, P/N 55-9020 (as needed)
To change the shaft seal:
1. Remove the compressor from the unit (see removal procedure above).
2. Clean dirt from shaft seal cover.
3. Remove key from shaft.
4. Remove 4 screws from shaft seal cover.
5. Carefully pry the shaft seal cover from compressor body using the flats on the shaft seal cover.
6. Loosen the set screws on the rotating seal member. Remove the seal from the shaft. Do not lose the spacer on the shaft.
7. Lubricate the O-ring in new rotating seal member. Use polyol ester compressor oil, P/N 203-433.
TKO Scroll Compressor Components
1.
Pulley
2.
Shaft Seal Assembly
3.
Oil Filter Cover Plate
4.
Compressor High Temperature Switch
5.
Cap
6.
Oil Filter and Gasket
7.
Oil Drain Cap Location
8.
Liquid Injection Fitting
aga660r
Summary of Contents for T-1000R
