Operating Instructions
74
NOTE: Cycle Sentry Mode or Continuous Mode can also be
selected using the Main Menu > Mode Submenu.
If the unit is in Cycle Sentry Mode, pressing the Cycle
Sentry/Continuous Key changes the mode from Cycle Sentry
Mode to Continuous Mode. The display confirms the change,
as shown in Figure 70.
Figure 70: Continuous Mode
The new mode is confirmed for 3 seconds (Figure 71).
Figure 71: New Mode Confirmed
The display then returns to the Standard Display. In the
example shown in Figure 72 the absence of the Cycle Sentry
Icon indicates that the unit is running in Continuous Mode.
Figure 72: Cycle Sentry Icon Not Shown =
Continuous Mode
ON
OFF
PROGRAMMING CONT MODE
PLEASE WAIT
ON
OFF
NEW SYSTEM MODE IS
CONTINUOUS
ON
OFF
MENU
35
°F
35
SET
SENSORS
GAUGES
POINT
.8
Summary of Contents for Precedent S-600
