Operating Instructions
62
Failure to confirm the new product by pressing Yes or No
within 10 seconds of changing the product will result in no
product change. In addition, Alarm Code 127 Setpoint Not
Entered is set, to indicate that the product change was initiated
but not completed.
Figure 50: Yes and No Keys
After the YES Key has been pressed, the display briefly shows
PROGRAMMING NAMED PRODUCT - PLEASE WAIT.
The display then confirms the new setpoint for several
seconds.
Figure 51: New Named Product
If the NO Key is pressed the display will briefly show
SETPOINT NOT CHANGED and return to the Standard
Display. The Standard Display will show the old setpoint.
The display then returns to the Standard Display showing the
new named product. Notice that the arrow points down, to
indicate that the unit is cooling (Figure 52).
-
NO
NEW PRODUCT WILL BE
+
+/- TO CHANGE
OK?
YES
POTATO, LATE CROP
ON
OFF
NEW NAMED PRODUCT IS
POTATO, LATE CROP
ON
OFF
Summary of Contents for Precedent S-600
