2
Installation
Making the Initial Back Panel Connections
Thermo Scientific
Accela Pump Hardware Manual
13
Making the Initial Back Panel Connections
Before you can operate the Accela Pump, connect the power cable and the USB
communication cable. To operate the Accela Pump as part of the LC system, connect the
interconnect cable that is used to coordinate the operation of the pump with the other Accela
modules.
Figure 6
shows the back panel of the pump.
To make the back panel connections, follow these procedures:
•
Connecting the Power Cable
•
Connecting the USB Cable
•
Connecting the System Interconnect Cable
Figure 6.
Back panel of the Accela Pump
Note
Earlier versions of the Accela Pump do not have a digital I/O port. In addition, the
fan vents on earlier versions of the Accela Pump are located on the bottom of the pump,
instead of the back panel.
Accela Pump
60057-60010
12472
5,653,876
6,248,157B1
61010 - 1
Model:
Serial No:
Part No:
Options/Firmware:
This product is manufactured under, and covered by,
one or more of the following U.S. patents:
355 River Oaks Parkway
San Jose, CA 95134 U.S.A.
This device complies with FCC Rules, Part 15.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
DISCONNECT INPUT
POWER BEFORE
OPENING COVER.
REFER ALL SERVICE
TO QUALIFIED
PERSONNEL ONLY.
CAUTION
Line power
receptacle
USB port
Input and output
signal pins
