Teledyne T360, Operation Manual, Page: 27 / 358

25
3.
GETTING STARTED
3.1. UNPACKING AND INITIAL SET UP
CAUTION
To avoid personal injury, always use two persons to lift and carry the
Model T360.
WARNING
Never disconnect PCAs, wiring harnesses or electronic subassemblies
while the instrument is under power.
NOTE
It is recommended that you store shipping containers/materials for future use if/when the instrument should
be returned to the factory for repair and/or calibration service. See Warranty page in this manual and
shipping procedures on our Website at:
http://www.teledyne-api.com under Customer Support > Return Authorization.
1. Verify that there is no apparent external shipping damage. If damage has
occurred, please advise the shipper first, then Teledyne Instruments.
2. Included with your analyzer is a printed record of the final performance
characterization performed on your instrument at the factory. This record,
titled Final Test and Validation Data Sheet (P/N 04596) is an important
quality assurance and calibration record for this instrument. It should be
placed in the quality records file for this instrument.
3. Carefully remove the top cover of the analyzer and check for internal
shipping damage.

Remove the set-screw located in the top, center of the Front panel.

Remove the 2 screws fastening the top cover to the unit (one per side
towards the rear).

Slide the cover backwards until it clears the analyzer’s front bezel.

Lift the cover straight up.
CAUTION – Avoid Warranty Invalidation
Printed circuit assemblies (PCAs) are sensitive to electro-static
discharges too small to be felt by the human nervous system. Damage
resulting from failure to use ESD protection when working with
electronic assemblies will void the instrument warranty.
See
A Primer on Electro-Static Discharge
in this manual for more information
on preventing ESD damage.
07272B DCN6552