Teledyne T360, Operation Manual, Page: 183 / 358

Teledyne API Model T360/T360M Operation Manual Calibration Procedures
181
The following example sets Sequence #2 to do a Zero-Span Calibration every
other day starting at 1 am on September 4, 2001, lasting 15 minutes, without
calibration. This will start ½ hour later each iteration.
MODE AND ATTRIBUTE VALUE COMMENT
Sequence 2 Define Sequence #2
Mode ZERO-SPAN Select Zero and Span Mode
Timer Enable ON Enable the timer
Starting Date Sept. 4, 2001 Start after Sept 4, 2001
Starting Time 01:00 First Span starts at 1:00AM
Delta Days 2 Do Sequence #2 every other day
Delta Time 00:30 Do Sequence #2 ½ hr later each day
Duration 15.0 Operate Span valve for 15 min
Calibrate NO Do not calibrate at end of Sequence
NOTES

The programmed STARTING_TIME must be a minimum of 5 minutes later tha The real time
clock (see Section 4.10 for setting real time clock).

Avoid setting two or more sequences at the same time of the day. Any new sequence which is
initiated whether from a timer, the COM ports, or the contact closure inputs will override any
sequence which is in progress.

If at any time an illegal entry is selected (Example: Delta Days > 367) the ENTR button will
disappear from the display.
07272B DCN6552