Teledyne T360, Operation Manual, Page: 135 / 358

Teledyne API Model T360/T360M Operation Manual Operating Instructions
133
4.13.2. Signal I/O
The signal I/O diagnostic mode allows reviewing and changing the digital and
analog input/output functions of the analyzer. See Appendix A-4 for a complete
list of the parameters available for review under this menu.
NOTE
Any changes of signal I/O settings will remain in effect only until the signal I/O menu is exited.
Exceptions are the ozone generator override and the flow sensor calibration, which remain as
entered when exiting.
To enter the signal I/O test mode, press:
SAMPLE RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
EXAMPLE
SAMPLE ENTER SETUP PASS: 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
DIAG SIGNAL I / O
PREV NEXT JUMP ENTR EXIT
DIAG I / O
Test Signals Displayed Here
PREV NEXT JUMP PRNT EXIT
Use JUMP to go
directly to a specific
signal location
See Appendix A-4 for
a complete list of
available SIGNALS
DIAG I / O JUMP TO: 12
1 2 ENTR EXIT
EXAMPLE:
Enter 12 to Jump to
12) ST_CONC_VALID
DIAG I / O ST_CONC_VALID = ON
PREV NEXT JUMP ON PRNT EXIT
Exit to return
to the
DIAG menu
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
Use NEXT & PREV to
move between signal
types.
Pressing PRNT will send a formatted printout to the serial port and can be captured
with a computer or other output device.
EXIT returns
to the main
SAMPLE display
07272B DCN6552