Teledyne T360, Operation Manual, Page: 161 / 358

Teledyne API Model T360/T360M Operation Manual Operating Instructions
159
To initialize the modem press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET
COM1 COM2 EXIT
EXIT returns to
the previous
menu
SETUP X.X COM1 MODEM INIT:AT Y

&D

&H
<SET
SET> EDIT EXIT
SETUP X.X COM1 INITIALIZE MODEM
<SET SET> INIT EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT EXIT
EXIT returns to the
Communications Menu.
SETUP X.X INITIALIZING MODEM
<SET
SET> INIT EXIT
4.15.2.7. COM PORT PASSWORD SECURITY
In order to provide security for remote access of the T360, a LOGON feature can
be enabled to require a password before the instrument will accept commands.
This is done by turning on the
SECURITY MODE (Mode 4, Section 4.11.5).
Once the SECURITY MODE is enabled, the following items apply.

A password is required before the port will respond or pass on commands.

If the port is inactive for one hour, it will automatically logoff, which can also
be achieved with the LOGOFF command.

Three unsuccessful attempts to log on with an incorrect password will cause
subsequent logins to be disabled for 1 hour, even if the correct password is
used.

If not logged on, the only active command is the '?' request for the help
screen.

The following messages will be returned at logon:

LOGON SUCCESSFUL - Correct password given

LOGON FAILED - Password not given or incorrect

LOGOFF SUCCESSFUL - Connection terminated successfully
To log on to the Model T360 analyzer with SECURITY MODE feature enabled,
type:
LOGON 940331
07272B DCN6552