Teledyne T360, Operation Manual, Page: 110 / 358

Operating Instructions Teledyne API Model T360/T360M Operation Manual
108
Teledyne Instruments analyzers have different default ID numbers, but if two
analyzers of the same model type are used on one channel (for example, two
T360’s), the ID of one instrument needs to be changed.
The ID can also be used for to identify any one of several analyzers attached to
the same network but situated in different physical locations.
4.11.2. COM Port Default Settings
Received from the factory, the analyzer is set up to emulate a DCE or modem,
with pin 3 of the DB-9 connector designated for receiving data and pin 2
designated for sending data.

COM1 : RS-232 (fixed) DB-9 male connector.
o
Baud rate : 115200 bits per second (baud).
o
Data Bits : 8 data bits with 1 stop bit.
o
Parity : None.

COM2 : RS-232 (configurable), DB-9 female connector.
o
Baud rate : 19200 bits per second (baud).
o
Data Bits : 8 data bits with 1 stop bit.
o
Parity : None.
NOTE
Cables that appear to be compatible because of matching connectors may incorporate internal
wiring that make the link inoperable. Check cables acquired from sources other tha Teledyne
Instruments for pin assignments before using.
In its default configuration, the T360 analyzer has two available RS-232 Com
ports accessible via 2 DB-9 connectors on the back panel of the instrument. The
COM1 connector is a male DB-9 connector and the COM2 is a female DB9
connector.
07272B DCN6552