Teledyne 3700, Installation And Operation Manual

Page: 214 / 242

3700 Portable Samplers
Appendix D Display Index
D-4
This display appears if you select “TIME” in Display #40. Enter the amount of time each bottle is to receive samples.
Display 42
CHANGE BOTTLES EVERY
-- HOURS -- MINUTES
This display appears if you select “TIME” in Display #41. Enter the amount of time each bottle set receives samples.
Display 43
CHANGE SETS EVERY
-- HOURS -- MINUTES
This display appears after you select “SAMPLES” in Display #40. Enter the number of samples each bottle receives.
Display 44
CHANGE BOTTLES EVERY
-- SAMPLES
This display appears after you select “SAMPLES/BTL” in Display #41. Enter the number of samples each bottle set is
to receive.
Display 45
CHANGE SETS EVERY
-- SAMPLES
This display appears when you select “yes”” in Display #95. Enter the time of the first bottle switch. The remaining
bottle changes will occur according to settings entered in Display #42. The display will also appear if you have started
the routine after the programmed switch time.
Display 46
FIRST BOTTLE CHANGE
AT
HH:MM MM/DD
This display appears when you select “YES” in Display #95. Enter the time of the first-bottle set switch. The remaining
bottle-set changes will occur according to settings entered in Display #43. The display will also appear if you start the
routine after the programmed switch time.
Display 47
FIRST SET CHANGE AT
HH:MM MM/DD
This display appears when the sampler is configured for 2-, 4-, 8-, 12-, or 24- bottle configurations under uniform time,
flow, or nonuniform time modes of sample pacing. Select “YES” to sample continuously. Select “NO” to stop the sam-
pling routine after the last set of bottles has been filled.
Display 48
SAMPLE CONTINUOUSLY?
[YES, NO]
Enter the size of the sample volume. MAX will vary according to the number of samples per bottle and bottle size.
Display 50
SAMPLE VOLUMES OF
--- ml EACH
(10 -
MAX
)
This display appears when you have configured the controller for composite sampling by selecting “1” in Display #221
or #222. Enter the number of composite samples. An entry of “0” instructs the sampler to take samples until a float
shut-off terminates the sampling routine.
Display 60
--- COMPOSITE
SAMPLES (0 -
MAX
)
This display appears when you select “YES” in Display #242 or select “DISABLE” in Display #240. Enter the mea-
sured suction head.
MAX will be the smaller of the suction line length or “20.”
Display 70
SUCTION HEAD OF
-- FEET (1 - MAX
)
This display appears in the program sequence when you have selected “ENABLE” in Display #290. Select “YES” to
use the calibration sequence, “NO” to omit the calibration sequence.
Display 80
CALIBRATE SAMPLE
VOLUME? [YES, NO]
Table D-1 Display Index (Continued)