Teledyne 3700, Installation And Operation Manual

Page: 79 / 242

3700 Portable Samplers
Section 3 Programming Guidelines
3-45
3.9.8 Save Current Program The Save Current Program option allows you to assign a dif-
ferent number to as many as three sampling routines and save
those numbers.
This option eliminates the need to reprogram the sampler for
recurrent routines. Only the program settings are saved; if dif-
ferent routines require different configurations, you must recon-
figure the sampler for each routine. For example, if the sampler
is used at two sites, each requiring a specific sampling routine
and different suction-line lengths, the sampling routines can be
stored for each site, but you must reenter the suction-line length
settings each time the line changes. (
Display #260 )
The sampler is shipped from the factory with four programs: the
current program and three stored programs, numbered from 1 to
3. All four programs contain the factory default program settings.
Saving a program will replace the default program with the
current settings. Reinitialization of the sampler restores the
default program settings, shown in Tables
3-4 and 3-5.
Note
Saving a program will overwrite a program saved earlier under
the same number. You can view settings for the current program
with the Display Status procedure. Example
Save Current Pro-
gram shows how to save a current sampling program.
LOAD PROGRAM
[#1, #2, #3, NONE]
8. When the sampler has loaded the program, it will display the next configure option. When you are done
configuring the sampler, press
EXIT
/
PROGRAM
to return to Standby.
SELECT OPTION: (
← →
)
SAVE CURRENT PROGRAM
9. After you properly install the sampler, press the
START SAMPLING
key to run the program.
. . . STANDBY . . .
10:37:23 19-JUN-04
Example: Load Stored Program (Continued)
Example: Save Current Program
1. Press
ENTER
/
PROGRAM
to access the interactive state.
. . . STANDBY . . .
10:34:50 19-JUN-04
2. Access the configure sequence by selecting “CONFIGURE.”
[PROGRAM,
CONFIGURE
]
SAMPLER
3. Press the
LEFT ARROW
or
RIGHT ARROW
key to scroll through the configure options. The first option displayed is
the Set Clock configure option.