2-21
Installation
Signal Processor Frame Installation
NOTE:
The Signal Processor Frame must be installed before either of the power supplies.
When planning your installation, ensure that the Frame will be installed high enough in
the equipment rack to allow 7 rack units for the installation of the Frame Primary Power
Supply (and another 7 rack units for the optional redundant Power Supply, if purchased)
below it.
To allow the use of extender modules and access for other maintenance, sufficient room
should be allowed in front of the equipment rack (
≥
41 inches, 105 cm)
. Sufficient room
should also be allowed in the rear of the rack for access to cables and the exhausting of
cooling air.
The Signal Processor Frame mounts in a standard 19-inch (48.3 cm) wide
equipment rack. It is installed in the rack from the front and secured at the front
edges of the Frame with screws (not provided by GVP). Its Power Supply mounts
below it in the rack on slide rails. The procedure for installing the Power Supply
follows the Frame installation procedure.
To install the Frame in the equipment rack, read the following precautions, then
refer to
and complete the following steps:
WARNING
The Model 4000 Signal Processor Frame weighs approximately 300 lbs (136
Kg) when fully configured. Provide appropriate equipment to support the
Frame during installation.
When the Signal Processor Frame and Power Supply are installed, the
equipment rack is top heavy and could topple. Ensure that the equipment
rack is attached solidly to the floor/building to prevent tipping when the
Frame and Power Supply are installed.
When lifting the Frame into place in the equipment rack, it is recommended
that a mechanical lifting device, such as a hydraulic forklift truck, be used.
Ensure that the bottom plate of the Frame is protected from damage while the
Frame is being lifted into the equipment rack.
Summary of Contents for Grass Valley 4000
