4-7
Signal Processor Frame Servicing
To reinstall modules in the A and B Bays of the Signal Processor Frame, do the
following:
1.
Place the module in the correct slot. Align the module in the guides and gently
slide it in as far as it will easily travel.
2.
Secure the module by moving the locking levers into the locked position,
thereby seating the edge connector. See
To remove a circuit module from the rear C or D Bays of the Signal Processor
Frame, proceed as follows:
1.
If necessary uncable the cables attached to the modules. Make sure the cables
are labeled for proper reconnnection. Remove the modules by first unscrewing
the screws at the top and bottom of each module.
2.
Unlock the top and bottom ejectors as illustrated in
them away from each other. Pull the circuit module straight out and away
from the frame.
3.
Set the module on a static free surface and be aware there are fragile
components on either side of the circuit board.
0621-208
Figure 4-2. C and D Bay Module Removal
Summary of Contents for Grass Valley 4000
