Sym Citycom.300i, Service Manual

Page: 45 / 270

3. LUBRICATION SYSTEM
3-7
Gear Oil
Oil level inspection
Park the motorcycle on flat surface with main
stand.
Turn off engine and remove oil inspection bolt.
Gear lubrication oil quantity has to be measured
with measure device.
If oil level is too low, add gear oil. Recommended
using
LIQUI MOLY gear oil 75W-90.
Install oil inspection bolt.
Gear Oil Change
Remove oil level inspection bolt.
Remove drain plug and drain oil out.
Install the drain plug after drained.
Torque value: 1.0~1.4kgf-m
Always replace the drain plug washer when
disassembled.
Add oil to specified quantity from the inspection
hole.
Gear Oil Quantity: 160 c.c. when replacing
Always replace the bolt washer when
disassembled, and install the bolt.
Start engine and run engine for 2-3 minutes.
Turn off engine and make sure that oil level is in
correct level.
Make sure that no oil leaking.
Gear oil Inspection Bolt
Gear oil drain plug
To this chapter contents