Supero SUPER 370DDE, User Manual

Page: 83 / 171

5-3
Chapter 5: The FastTrak 100 RIAD Card (370DDE)
5-2 Getting Started
This section is designed to get you started for installation of your
FastTrak100.
Unpacking Your FastTrak100
When you receive the FastTrak100, the package should contain the
items listed below:
·
FastTrak100 Ultra ATA/100 RAID Card
·
FastTrak100 User’s Manual
·
Registration Card
·
FastTrak100 Driver floppy diskette
·
Two Internal 80-wire/40-pin Ultra ATA/100 hard drive cables (18”
length)
If ANY of the contents are missing or appear to be damaged, please
contact your dealer or distributor immediately.
WARNING: Before installing the adapter into an existing
system, backup any necessary data. Failure to follow this accepted PC
practice could result in data loss.
NOTE: FastTrak100, like every other valuable part of your system, is
subject to static electricity. Be sure that you’re properly grounded
(Promise recommends that you wear an anti-static strap, or touch a
grounded object), and that your system is unplugged before installing
FastTrak100.
Installing The Card
Installing the FastTrak100 controller card in a system is a simple process.
The card fits into any available 32-bit PCI slot on the system’s motherboard
(see figure below).
1.
Remove the cover of your system.
2. Remove the inside slot cover of an available 32-bit PCI slot on the
motherboard.
3. Install the FastTrak100 controller card into the open slot (see Figure
1 below).
4. Attach your system case’s 2- or 4-pin LED cable to the LED connector
on the FastTrak100 controller card (see figure next page). Make sure
that pin 1 on the connector is aligned with pin 1 of the cable.
5. Fasten the controller card bracket to the system case (see below).