Supero SUPER 370DDE, User Manual

Page: 90 / 171

5-10
S
UPER 370DDE/370SDA User's Manual
Troubleshooting
WARNING: If you wish to include your current bootable drive using the
Windows NT 4.x or Windows 2000 operating system as part of a
bootable Mirrored (RAID 1) array on your FastTrak100, do NOT con-
nect the hard drive to the FastTrak100 controller yet. You MUST install
the Windows NT4 or 2000 driver software first (see page 5-24) to this
drive while it is still attached to your existing hard drive controller. For
all other Operating Systems, proceed here.
Follow these steps:
1. Using the Spacebar, choose “Security” under the Optimize Array
for section.
2. Press <Ctrl-Y> keys to Save your selection. The window below will
appear.
3. Press “Y” for the Create and Duplicate option. The window below will
appear asking you to select the Source drive to use. FastBuild will
copy all data from the Source drive to the Target drive.
4. Use the arrow keys to choose which drive contains the existing
data to be copied.
5. Press [Ctrl-Y] keys to Save selection and start duplication. The
following progress screen will appear.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
Source Disk
Channel:ID Drive Model Capacity (MB)
Target Disk
Channel:ID Drive Model Capacity (MB)
[Please Select A Source Disk]
Channel:ID Drive Model Capacity (MB)
1 :Master QUANTUMCR8.4A 8063
2 :Master QUANTUMCR8.4A 8063
[
↑
] Up [
↓
] [ESC] Exit [Ctrl-Y] Save
Start to duplicate the image . . .
Do you want to continue? (Yes/No)
Y – Continue N - Abort
WARNING: Backup any necessary data before proceeding.
Failure to follow this accepted PC practice could result in
data loss.