Supero SUPER 370DDE, User Manual

Page: 99 / 171

5-19
Chapter 5: The FastTrak 100 RIAD Card (370DDE)
3. Use the arrow keys to choose which drive contains the existing
data to be copied.
4. Press [Ctrl-Y] keys to Save selection and start duplication. The
following confirmation screen will appear.
5. Select “Y” to continue. If you choose “N” , you will be returned to
step 1.
6. Once “Y” is selected, the following progress screen will appear.
The process will take a few minutes.
7. Once mirroring is complete, the following screen will appear
confirming that your Security array has been created. Press any
key to reboot the system
Making a FastTrak100 Disk Array Bootable
1. Once you have returned to the Define Array Menu window (below), you
will see the array(s) you have created. You now may use the menu to
select which previously-defined array will be used as the bootable
array.
Please Wait While Duplicating The Image
10% Complete
Array has been created.
<Press Any Key to Reboot>
FastBuild (tm) Utility 1.xx DELL (c) 1995-2000 Promise Technology, Inc.
[ Define Array Menu ]
Array No RAID Mode Total Drv Capacity(MB) Status
* Array 1 Stripe 2 13044 Functional
Note: * — Bootable Array
[
↑
] Up [
↓
] Down [ESC] Exit [Enter] Select [Space] Change Boot Drive
Start to duplicate the image . . .
Do you want to continue? (Yes/No)
Y – Continue N - Abort
WARNING: All target drive data will be erased.
Make sure you choose the correct drive.
WARNING: In order for you to boot from an array on the
FastTrak100, your PC or server must be configured in
the CMOS Setup to use the FastTrak100 as a bootable
device (versus the onboard controller or another add-in
card). This option is not available if the FastTrak100 is
being used as a secondary controller.