Supero SUPER 370DDE, User Manual

Page: 107 / 171

5-27
Chapter 5: The FastTrak 100 RIAD Card (370DDE)
1. After installing the FastTrak100 controller card and configuring the
hard drives, power up the system and boot.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI RAID Controller.”
3. Click on “Next,” and from the generated list box, choose “Search for
a better driver than the one your device is using now.”
4. Click on “Next,” and from the generated choices, choose “Specify a
location.”
5. Insert the “FastTrak100 Driver” diskette in drive A:.
6. Type “A:\WINME” in the text box that appears.
7. Click on “Next.” A message informing you that Windows Millennium
has found “Windows Millennium Promise FastTrak100 Controller”
should appear.
8. Click on “Next,” and then on “Finish.”
9. Choose “Yes” when asked if you want to restart your computer. Be
sure to eject the diskette from drive A:.
Confirming Driver Installation in Millennium
To confirm that the driver has been properly loaded in Millennium, perform
the following steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double-click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of
“SCSI & RAID controllers.” “Windows Millennium Promise FastTrak100
Controller” should appear.
Windows 95/98
Installing Drivers During Windows 95/98 Installation
The following three sections detail the installation of the FastTrak100
drivers while installing Windows 95/98 (with the FastTrak100 controller
card already in place). If you’re installing the FastTrak100 drivers on a
system with Windows 95/98 already installed, see “Installing Drivers with
Existing Windows 95/98” on page 5-29.