Supero SUPER 370DDE, User Manual

Page: 89 / 171

5-9
Chapter 5: The FastTrak 100 RIAD Card (370DDE)
Creating a Security Array With New Drives
NOTE: FastTrak100 permits only two drives to be used for a single
Mirrored array in Auto Setup. If more drives are physically attached to
the card, the Mirroring option will not be available at all in Auto Setup.
To create an array for data protection using new hard drives, follow
these steps:
1. Using the Spacebar, choose “Security” under the Optimize Array
for section.
2. Press <Ctrl-Y> keys to Save your selection.
3. The window below will appear.
4. Press “N” for the Create Only option.
5. A window will appear almost immediately confirming that your
Security array has been created. Press any key to reboot the
system
6. Proceed with normal FDISK and format procedures as if you had
just installed a new hard drive.
7. Once the arrayed drives have been formatted, proceed to the
Installing Driver chapter on page 31 to install your operating
system and/or FastTrak100 driver.
Creating a Security Array With An Existing Data Drive
NOTE: FastTrak100 permits only two drives to be used for a single
Mirrored array in Auto Setup. If more drives are physically attached to
the card, the Mirroring option will not be available.
You would use this method if you wish to use a drive that already
contains data and/or is the bootable system drive in your system. You
will need another drive of identical or larger storage capacity.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
Array has been created.
<Press Any Key to Reboot>