Supero SUPER 370DDE, User Manual

Page: 111 / 171

5-31
Chapter 5: The FastTrak 100 RIAD Card (370DDE)
NOTE: The FastTrak100 BIOS supports both DOS and Windows 3.1x
without software drivers.
Windows NT4
Installing Drivers During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installa-
tion diskettes.
b) Floppyless install: boot from floppy and type “WINNT /B”.
After files have been copied, the system will reboot. On the
reboot, press the “F6” key when the message “Setup is inspect-
ing your computer’s hardware configuration…” appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press
the “F6” key when the message “Setup is inspecting your com-
puter’s hardware configuration…” appears.
2. When the “Windows NT Setup” window is generated, press “S” to
Specify an Additional Device(s).
3. Press “O” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology Ò FastTrak100 driver diskette into drive
A: and press the “Enter” key.
5. Choose “Win NT Promise FastTrak100 (tm) Controller” from the list
that appears on screen, then press the “Enter” key.
6. The Windows NT Setup screen will appear again saying “Setup will
load support for the following mass storage devices:” The list will
include “Win NT Promise FastTrak100 (tm) controller”.
NOTE: If you need to specify any additional devices to be installed,
do so at this time. Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will
now load all device files and then continue the Windows NT installa-
tion.
8. After a successful installation, the “SCSI Adapter Setup” box will
show that the “Win NT Promise FastTrak100 (tm) Controller” driver has
been installed.