Sunbeam ALPINE I SERIES: APLINE II SERIES, Workshop Manual

Page: 393 / 413

Page 11
Fis, JO. Boot lid and lock attachment points (Rapier)
BONNET LOCK-To remove
Alpine
Remove the cotter pin and flat washer retaining
the control rod slide and lift off slide.
Take out the three setscrews with their washers
and lift off lock.
To remove the striker unit (Fig. 29), take out the
two setscrews (I) with their flat and spring
washers.
Fl1.
31.
Boot lid attachment points
(Alpine)
6
WSM.124
Section O (Body)
L:
--===::W'
Fi1, 32. Components of the boot lid lock (Rapier)
I. LOCKING BARREL
5. SPRING
2. PUSH-BUTTON
6. PUSH-BUTTON ASSEMBLY
3. HOUSING
7. BRACKET
4. LOCK
Replace both striker unit and lock by reversing
the above procedure.
Adjustment of the striker Is carried out by screwing
in or out of the striker pin, finally locking up with
the locknut.
BOOT LID-To remove
Rapier (Fig. 30)
Disconnect the battery from the positive terminal
515+
Fi1. 33. Components of the boot lid lock (Alpine)
1. STRIKER PLATE 3. LOCK
2. OPERATING KNOB 4. SEAL
·...__,I