Sunbeam ALPINE I SERIES: APLINE II SERIES, Workshop Manual

Page: 408 / 413

•
ROOTES MAN UAL 124
Section R (Heater)
BLOWER-To remove and refit.
Disconnect the battery.
Release the branch pipe at the wing valance and
remove air hose between branch pipe and blower.
Disconnect blower cable at the snap tube con­
nector.
Remove blower securing screws and withdraw
blower complete with the rubber elbow.
Refitting is a reversal of the above operations, re­
connect battery, start clock (if fitted) and test
blower.
CONTROLS-To remove and refit (see Sections
"N and O").
Disconnect battery.
_l'j �
��
----
------
Page7
Remove control lever knobs (screw off).
Remove console and filler panel (Series IV only).
Release the lower facia panel.
Release control, disconnect cable and withdraw
control. On those models with the blower switch
incorporated in the control, disconnect the cables
at the snap connector and the In-line fuse.
Refitting is a reversal of the above operations. It is
important when refitting the cable that the outer
cable end is flush with its clamp and that the inner
cable protrudes t in. (3 mm.) through its trunnion.
(See also "ADJUSTMENTS".)
Re-connect battery and start clock (if fitted) .
Fis. 8. Heater-general arrangement (Rapier Ill-IV)