Sunbeam ALPINE I SERIES: APLINE II SERIES, Workshop Manual

Page: 391 / 413

Page 20
WINDOW REGULATOR-To remove
All models
Remove interior trim.
Temporarily replace window winding handle and
lower window to approximately halfway down and
support the glass.
Release the lower ends of the glass run channels.
Remove the screws securing the regulator to the
inner door panel. Spring the operating arms from
the location in the guide channel (carnplate) cf the
glass and remove regulator from the door.
Reference can be made to Figs. 12 and 13 for the
location of the various items.
To refit
Reverse the above procedure.
Fig. 24.
Removing retaining
screws
from window regulator
(Rapier)
QUARTER-LIGHT GLASS REGULATOR­
To remove
Rapier (Fig. 25)
Remove interior trim.
Temporarily replace window winding handle and
lower window to approximately halfway.
Release the operating arm from its location and
WSM.124
Section O (Body)
Fig. 25,
Removing quarter-light regulator (Rapier)
the screws securing the regulator co the inner
body panel.
To refit, reverse the above instructions.
BONNET-To remove
Rapier (Fig. 26)
Support the bonnet lid with a suitable sling in the
open position.
Remove the two setscrews with their respective
washers (2) from each bor,net hinge, whereupon
the bonnet Is free to be removed.
Replacement is a reversal of the above instructions.
Fig. 26.
Bonnet and lock attachment points
(Rapier)