ROOTES MANUAL WSM. 124
Section N (Elec. Equip.)
SIDE LAMPS AND FRONT FLASHER
BU LBS
Rapier IV models
(Refer to Fig. 27)
To renew a defective bulb, remove the two screws
and detach the white and amber lenses. Renew the
defective bulb(s) and refit the lenses, making sure
that the rubber seat is correctly located; secure
the lenses with the two screws.
Fig.
27.
Side lamps and front flasher bulbs
KEY TO
Fi1,
27
I, RETAINING RIM SCREWS
6. LAMP BODY
l. RUBBER
WASHER
7, LENS SEATING
3, RETAINING RIM
8. FLASHER BULB
4. CLEAR LENS
9. AMBER LENS
5. SIDE LAMP BULB
SIDE LAMPS-(Alpine
I, II and Ill
models)
(See Fig. 28)
The rim and glass are retained by shaped lips
formed In the rubber body. To renew bulbs, first
remove the rim by easing back the rubber lip and
then remove the glass by the same method. The lips
can be carefully eased back by means of a screw
driver.
Reassembly Is a reversal of the above instructions.
Fig. 28.
Side lamp details (Alpine 1, II and
/II)
6th re-issue
Page 29
SIDE LAMPS AND FRONT FLASHER
BULBS
Alpine IV models
(Refer to Fig. 29)
To renew a defective bulb, remove the three screws
and detach the white and amber lenses. Renew
the defective bulb(s) and refit the lenses, making
sure that rubber seat is correctly located; secure
the lenses with the two screws.
Fig, 29.
Side lamps and front flashers bulbs
KEY TO
Fis,
19
I. RETAINING SCREWS
5. FLASHER BULB
2. CLEAR LENS
6, LENS SEATING
3,
CAPLESS SIDE LAMP BULB
7.
LAMP BODY
4, AMBER LENS
8, RUBBER
PLINTH
STOP/TAIL AND FLASHER LAMPS
(Rapier)
Access for bulb renewal is available from within the
boot. The detachable bulbholder assembly is
retained by a single, central screw.
To renew lenses, remove bulbholder assembly from
lamp body. Remove two nuts and washers and
withdraw lamp unit outwards. Remove four self
tapping screws which retain lenses.
During reassembly, care must be taken to correctly
position the rubber sealing washers.
Summary of Contents for ALPINE I SERIES: APLINE II SERIES
