Sunbeam ALPINE I SERIES: APLINE II SERIES, Workshop Manual

Page: 383 / 413

Page 12
Fig.
13.
General view of door with trim pad removed
(A/pine)
WINDING WINDOW, DOOR-To remove
and refit
Alpine
Remove interior handles and trim pad.
Replace window winding handle temporarily and
lower window until the regulator guide channel
(camplate) is visible through the aperture in the
inner door panel.
Spring out the regulator operating arms from their
locations.
Remove the furflex anti-rattle strips by easing them
down with a screwdriver.
Release the front and rear glass channels.
Turn the window (Fig. 14) and lift up and out
through the aperture in the door.
When refitting, replace the anti-rattle strips first,
but leave the rear ends free.
After replacing the window, fit the rear ends of the
anti-rattle strips.
WSM.124
Section O (Body)
QUARTER-LIGHT GLASS-To remove and
refit
Rapier (Fig. 15)
Remove window winding handle.
Remove rear seat cushion and squab. The retaining
screws for the squab are accessible from inside the
boot.
Remove the trim panel from below the window
aperture.
Remove the cotter pin and large nut from the
quarter-light pivot.
Temporarily replace window winding handle and
lower window to approximately the half-way
position.
Release operating arm from its guide channel.
Pull the glass assembly by grasping the upper
forward edge, clear of its pivot, and up and out of
the body side.
NOTE: When removing the left hand light it Is
advisable to remove the Interior lamp. In which
case refer to Section N.
NO DRAUGHT VENTILATOR-To remove
and refit
Rapier
Remove winding window.
Remove
four
screws securing ventilator and frame
to the door, located as follows:-
Two at the upper and forward edge of the door.
One Immediately above the winding window
regulator, and one above the bottom stop.
Fig. 14.
Refitting winding glass
(Alpine)