Sun Microsystems StorEdge T3+, Service Manual

Page: 26 / 240

xxvi Sun StorEdge T3 and T3+ Array Field Service Manual • September 2001
How This Book Is Organized
This manual is organized as follows:
Chapter 1 provides a troubleshooting overview on the Sun StorEdge T3 and T3+
array.
Chapter 2 describes how to connect to and boot the Sun StorEdge T3 and T3+ array.
Chapter 3 provides the qualified service provider with troubleshooting techniques
for the Sun StorEdge T3 and T3+ array.
Chapter 4 describes how to monitor and replace the controller card, and upgrade the
firmware.
Chapter 5 describes how to monitor and replace the disk drives, and upgrade the
firmware.
Chapter 6 describes how to monitor and replace the interconnect card, and upgrade
the firmware.
Chapter 7 describes how to replace the power and cooling unit and monitor the
UPS.
Chapter 8 describes how to diagnose and correct back-end FC-AL drive loop
problems with the Sun StorEdge T3 and T3+ array.
Chapter 9 describes how to replace the chassis/backplane assembly.
Chapter 10 describes how to reconfigure the Sun StorEdge T3 array into partner
groups and single controller units.
Appendix A contains part numbers and illustrations of field-replaceable units.
Appendix B lists the Sun StorEdge T3 and T3+ array defaults.
Appendix C contains a description of the messages that can be reported by the array.
Appendix D contains descriptions of the commands supported by the Sun StorEdge
T3 and T3+ array.
Appendix E lists the FC-AL loop identified by AL_PA switch and setting values.
Appendix F contains a blank worksheet for the qualified service provider to make
notes at each customer site.