Sun Microsystems StorEdge T3+, Service Manual

Page: 108 / 240

6-4 Sun StorEdge T3 and T3+ Array Field Service Manual • September 2001
4. Unlock the failed interconnect card by pushing in on the latch handle.
Use a coin or small screwdriver to press in and release the latch handle.
FIGURE 6-2
Removing the Interconnect Card
5. Pull the interconnect card out using the latch handle.
Caution –
The interconnect card that is removed must be replaced within 30
minutes or the Sun StorEdge T3 and T3+ array and all attached arrays will
automatically shut down and power off.
6. Insert the new interconnect card, making sure that the card sits on the frame.
7. Lock the new interconnect card in place by pushing in the latch handle.
Use a coin or small screwdriver to press in and secure the latch handle.
8. Reconnect the interconnect cable to the interconnect card.
9. Verify that the LEDs on the interconnect card show that the interconnect card has
initialized properly.
10. Verify the status of the interconnect card using either the CLI or Component
Manager.
Refer to Section 3.7.3, “Checking FRU Status” on page 3-18, or the Sun StorEdge
Component Manager User’s Guide for instructions.
Latch handle