Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 39 / 128

Chapter 1 StorEdge S1 AC100 and DC100 Overview 3
■
Complete backward compatibility with existing Netra st D130 storage enclosure
and single-ended hosts
■
1 RU form factor, 19-inch rack-mountable, 18.6 inches deep
■
Choice of AC or DC power supplies
■
Offers isolated ground option and dual input (for DC power model only)
■
Three hot-swap SCSI drives
■
Front and back power and status LEDs
■
Rear SCSI ID base address selector and front LED binary indicators
■
Single-channel, self-terminating SCSI-3 high density connections
■
Dual SCSI connections for daisy-chaining or clustering
■
Ultra 3 SCSI (160 Mbyte/sec) interface to the host (also compatible with Ultra
SCSI and Ultra SCSI 2 interfaces)
■
Telcordia NEBS level 3 certification
■
Daisy-chaining of up to four StorEdge S1 in a SCSI chain
■
Daisy-chaining of StorEdge S1 and Netra st D130 storage enclosures (up to two
units per single-ended SCSI chain)
■
The length of LVD (Ultra 3) SCSI bus is up to 12 meters
■
StorEdge S1 Storage Subsystem Manager software
■
Inbuilt SCSI LED information card
Note –
A data transfer rate of 160 Mbyte/sec can be achieved only if the drivers
installed on both the host operating system and the system’s host bus adapter
support 160 Mbyte/sec. Refer to your operating system documentation for more
information.
Contents of the Ship Kit
The ship kit contains the following items:
■
StorEdge S1 AC100 or DC100 storage enclosure with either two or three installed
hard disk drives (depending on the configuration you have purchased)
■
Power connectors
■
AC version: one AC power cord
■
DC version: DC connector kit
■
0.8-meter Cable SCSI-3 to SCSI-3 connector cable (X1134A)
■
Storage Subsystem Manager 2.0 CD-ROM
■
Rackmounting brackets and screws
■
Documentation
■
StorEdge S1 AC100 and DC100 Installation and Maintenance Manual