Sun Microsystems StorEdge S1 AC100, Installation And Maintenance Manual

Page: 98 / 128

62 StorEdge S1 AC100 and DC100 Installation and Maintenance Manual • March 2002
3. If necessary, create a mount point for the new file system:
where mount-point is a fully qualified path name. Refer to the
mount
(1M) man page
for more information.
4. After the file system and mount point have been created, modify the
/etc/vfstab
file to reflect the new file system.
See the
vfstab(4) man page
for more details.
5. Mount the new file system using the
mount
command:
where mount-point is the directory you created.
The file system is now ready to be used.
Removing and Replacing a Hard Disk
Drive
The StorEdge S1 storage enclosure comes configured with 1-inch high drives. The
procedure for removing and replacing the drives differs only in the software you use
to control the disks. In all cases the hard disks are hot-swappable.
▼
To Remove a Hard Disk Drive
Caution –
If the StorEdge S1 storage enclosure is running and a drive slot does not
contain a hard disk drive or foam filler, the StorEdge S1 enclosure will not cool
properly and might overheat. If you do not replace the hard drive, you must install a
foam filler in the empty slot. The foam fillers are air baffles that allow the system to
maintain maximum cooling. Verify that you have either a replacement drive or a
foam filler before removing a disk drive from the enclosure.
# mkdir
mount-point
# mount /dev/dsk/cwtxdysz
mount-point